# Set the ip-address to load the bootloader from # set bootloader ip-address to connect from To flash u-boot now, run the following in the bootloader's shell
Press any key to stop autoboot when prompted.Īt this point you can make a backup of the original firmware using md.l 0xb0000000 0x1000000 and logging the output (takes roughly 2 hours). Send openwrt-lantiq-arv7510pw_ram-u-boot.asc as raw ascii to the router. The router now waits for bootloader code.
IBOX FLASH SERIAL
You should see the following on the serial output. Use baud rate 115200, 8-N-1, no flow control as the serial connection parameters. All functions of the device appear to work well and the latest 4.4 kernels are tracked quite promptly. The latest patches are already included and the firmware compiles without error. UPDATE: The LEDE project at has improved support for this device. It can be installed in the same manner as the squashfs.image as outlined below. The resulting firmware will be found in the directory bin/lantiq/ (with the name openwrt-lantiq-xway-ARV4510PW-squashfs-sysupgrade.bin). Compile per instructions for building a firmware image. To compile your own firmware, set up an OpenWrt compile system as described elsewhere on the site for trunk and place the two patches into the directory target/linux/lantiq/patches-4.4/. Many thanks to the author of these patches who originally provided them above! It applies, but does not seem to fix the WiFi. An EXPERIMENTAL untested version for latest OpenWrt here.
IBOX FLASH PATCH
NOTE: The patch is outdated for the latest trunk version. To get network and USB to work you need to apply the following patches: br-lan: port 1(eth0.1) entered forwarding state Use the "list" command to see which switches are device eth0.1 entered promiscuous mode IPv6: ADDRCONF(NETDEV_UP): eth0.1: link is not readyįailed to connect to the switch. br-lan: port 1(eth0.1) entered disabled state On the official build of Chaos Calmer (15.05) network does not work by /etc/init.d/network restart Trunk and Chaos Calmer (15.05) should work without extra patches since r44451.
Official OpenWrt 14.07 images for lantiq xway do not work due to missing patch for disabling buffered writes.
0 kommentar(er)
